KH1 Power Switch Guard Color:Red Simply plug this into the

Simply plug this into the USB-C from your power bank (cord may be required) and then plug in your radio power cord to the Amass XT60 Connector

This is a printed stand for the AX1 antenna

and other high-power devices

These boards are 3D printed in PLA+ for a higher temperature allowance and to better handle the outdoor elements

Wire length if included in selection is cut to length and terminated with banana connectors at the transformer and loops at the opposite ends

KH1 Power Switch Guard Color:Red Simply plug this into theHelp prevent your KH1 from turning on in the case! Don't pull out the KH1 to find its dead! Printed in UV resistant, high temp ASA Filament. Hardware included. Insert square nut into slot and screw in from inside back radio cover as seen in photo. Radio Not Included!